Medic+Air Standard Air Compressors

Add the demand of equipment that may operate at the same time and allow sensible headroom. Avoid sizing from the number of chairs or devices alone.

Both models have an 8 bar maximum rating. Confirm the pressure required at the point of use after pipework, filtration and other treatment losses.

The MED320 requires 230V single phase and the MED640 requires 400V three phase. Protection, isolation and wiring should be confirmed by a competent electrician.

The 50L and 90L receivers provide local stored air, but receiver volume does not replace correct compressor sizing or determine the usable airflow on its own.

The standard Medic+Air models are not acoustically enclosed Dr Sonic machines. Installation location, ventilation and separation from occupied areas should therefore be considered.

Check expected running pattern, simultaneous demand and recovery requirements. Repeated operation close to maximum capacity may justify additional headroom.

Allow suitable ventilation, access for servicing, vibration control, drainage, safe electrical isolation and correctly sized distribution pipework.

These Standard models have no integrated dryer. Specify appropriate moisture control and filtration according to the required air quality at the point of use.

Confirm the requirements of the connected equipment and any applicable project, practice, clinical or regulatory specification before choosing the complete system.